Water Polo Operation; Physical Setup; Displaying Information; Shot Time - Colorado time systems Pro Pace Clock User Manual

Physical Setup

Displaying
Information

Shot time

Water Polo Operation

Mode Switch Setting
1
3
5
12
16
Clocks connected to a CTS timer running Water Polo software can
be used to display all of the information shown in the chart above.
Set the Scoreboard/Training switch to Scoreboard. Connect one
clock to the timer through the scoreboard output port with a data ca-
ble using either the round 4-pin (RS-485) connector or the quar-
ter-inch phono connector (RS-232), whichever your timer supports.
Connect the clocks to each other with the same type of data cable.
Each clock will display the information based on its mode setting: a
series of connected clocks will display different information from
one another if they are set to different mode settings.
Clocks can be used to display shot time and other information for
Water Polo, with the timer default settings. Connect them as de-
scribed in Physical Setup. Turn the clock(s) on. Set the Train-
ing/Scoreboard switch to Scoreboard. The clock(s) will display in-
formation from the CTS timer based on the setting of the Mode dial.
See your CTS timer Water Polo software manual for information
about shot time, game time, time out time, team scores or setting
time of day.
To display shot time on clocks, the CTS timer must be set to display
Scoreboard Channel 02 (shot time) on Module 03. Set the Mode
Display
Game Clock
Shot Clock
Time Out Clock
Team Scores
Time of Day
Water Polo Operation
3
7