Mode; Physical Connections; Scoreboard/Training - Colorado time systems Pro Pace Clock User Manual

Introduction

Mode

Physical
Connections

Scoreboard/Training

2
After the Mode switch has been in the same intensity setting for 4
seconds, the clock will display the firmware revision, and then the
current mode. At this point, the Mode switch changes the mode (and
only the mode) until the clock is turned off and then on again.
The physical connections are on the left side of the front panel.
When the switch is set to scoreboard, and the clock is connected to
a timer or controller through the quarter-inch phono plug (RS-232)
or the round 4-pin connector (RS-485), the clock will display infor-
mation from the timer or controller based on the clock's Mode switch
setting. See Chapter 3, beginning on page 7, for information that can
be displayed for Water Polo, and Chapter 5, beginning on page 19,
for other information that can be displayed.