Uncrating, Positioning And Leveling; Accessing The Utility Connections - Meiko DV 120.2 Owner's Installation, Operation And Maintenance Manual

3.3 Uncrating, Positioning and Leveling

1. Remove all shipping and packaging material
from the appliance, including supports and
wrappings. Leave the shipping skid in place at
this time to allow for easier movement to the
installation location.
2. Check for shipping damage as described in
Section 2, "Transport and Shipping." If damage
is present, call MEIKO Customer Service at
1-800-868-3840, providing full details on the
customer, serial number and extent of damage
present. MEIKO will file a freight claim based
on this information.
3. Move the appliance to the installation area and
remove the skid. Use caution to avoid damaging
the appliance or any of its components.
4. Using a spirit level, check that the appliance is
level in both directions (front-to-back AND side-
to-side). If necessary, level the appliance by
rotating the bottom section of each foot.
CAUTION
The utensil washer MUST be level for proper
operation.

3.4 Accessing the Utility Connections

Water supply and drain connections are located
at the lower rear of the utensil washer. The electrical
supply enters through a strain relief at the lower
rear, but the terminal blocks are accessed from
the front of the machine.
To remove the lower front panel:
1. Remove AND RETAIN the two screws on the
bottom edge of the lower front panel. See
Figure 3-1.
2. Slide the panel down and away from the utensil
washer to remove it. As you pull the panel away
from the utensil washer, disconnect the ribbon
cable for the MIKE 2 controller to avoid damage.
3. Remove the screw that holds the electrical box
in place, as shown in Figure 3-2. Swing the box
down as shown in Figure 3-3. The main
electrical supply terminal block is on the left
side of the machine. The chemical dispenser
terminal block (if used) is underneath the wash
tank on the right side of the machine.
Figure 3-1
SEL
NO EC
RM T
CY CL AL
E SEL
EX EC TEN
CY DE T
CL D
E SEL
W AS HE EC T
H CY AV Y
TA NK CL E
TE MP
MI N.
15
0° F FI
/ 66 NA L
°C RI
NS E
TE
MI MP
N.
18 0°
F / 82
°C
Pr
es
"S s "S
TA RT TO
" to P"
dr th en
ain
Remove
2 screws on
bottom edge
Figure 3-2
Remove
screw
Electrical
box
Figure 3-3
Main
electrical
supply
terminal
block
Swing
electrical
box down
S 3 - I
ECTION NSTALLATION
As panel is
removed, disconnect
ribbon cable to
MIKE 2 controller
Chemical
dispenser
terminal
block (if
used)
Page 5