Troubleshooting - Meiko DV 120.2 Owner's Installation, Operation And Maintenance Manual

S 6 - T
ECTION ROUBLESHOOTING
6 T
ROUBLESHOOTING
If the utensil washer encounters a problem, an Info Code or Error Code will usually appear in
the display. If you use this troubleshooting guide to resolve simple problems, you can often
return the appliance to operation faster than by placing a service call.
Info Codes appear for minor difficulties. Error codes appear for more complex issues. After
correcting the condition, if the unit does not return to normal operation automatically, press
the START/DRAIN (
Display Shows
You should contact your
• The utensil washer encounters a problem but does not display
an error code, OR
• An error code appears that is not shown here, OR
• The listed action fails to correct the problem.
An Authorized Service Agency Listing was supplied with your
utensil washer. If you do not have the listing, call 1-800-868-3840
for assistance.
Page 20
)key or the STOP/OFF (
Problem
Tank is not heating OR
fresh water is not
entering unit
Door is not closed OR
door switch is defective
Water leakage onto floor
pan
Correct water level was
not reached during initial
filling
Filling process takes too
long
MEIKO Authorized Service Agent
) key to clear the message.
O
Action
Check that the water hose is correctly
attached and is free of "kinks" or
pinching. Also check that the water
supply is turned on.
Check that the door is completely
closed.
Check that the water line to the unit is
not leaking, and that the drain hose
empties correctly into the drain.
Check that the water hose is correctly
attached and is free of "kinks" or
pinching. Also check that the water
supply is turned on.
Check that the water hose is correctly
attached and is free of "kinks" or
pinching. Also check that the water
supply is turned on.
IF: