QMS 1660 Reference Manual page 80

Notes
The amount of memory needed for this memory client depends on the
size and number of hard disks, the number of subdirectories on each
disk, and the amount of memory dedicated to caching.
Note: If sufficient memory is available to the disk cache, all disks are
»
accessible. If insufficient memory is available to the disk cache, some
disks may be accessible while others may not be.
The recommended amount of memory for the disk cache client is
120 KB minimum
0.5 KB per MB of disk storage total for all disks
For example, the recommended amount of memory for the disk
cache for a single 120 MB hard disk is 180 KB, and for two 120 MB
hard disks it is 240 KB. These are recommended values. The printer
will still operate with a smaller cache, but decreased performance
may result.
The K Mem Display memory client is the number of kilobytes of RAM
dedicated to the display lists. The display list holds the intermediate
representation of pages to be printed.
Menu
Choices
Default
Notes
If no hard disk is used, the disk cache should be set to the
minimum. The printer then reallocates the released memory to
other clients that need additional memory.
If one or more hard disks are used, they remain unavailable
until sufficient memory is available to the disk cache.
If you change the K Mem Disk Cache value, the printer
automatically restarts after you save your changes and exit
from the configuration menu.
Administration/Memory/K Mem Display
00128-12288
00208
If you change the K Mem Display value, the printer
automatically restarts after you save your changes and exit
from the configuration menu.