QMS 1660 Reference Manual page 124

Emulation Temporary:
Disk Cache:
System Use:
Total Memory:
PostScript Emulation VM:
VM allocated:
VM remaining:
Paper Size:
Resolution:
When sending print jobs through the serial and parallel protocols,
some applications and their printer drivers append an end-of-docu-
ment command (EOD) to each print job to ensure that each file prints
correctly. The reason for this is that some protocols and print queuing
systems send print jobs to the printer as one continuous data stream
(one print job immediately following another).
But the problem with this system is that some applications are limited
by the printer language and are unable to produce an EOD com-
mand. This becomes even more problematic when you're printing to
a QMS 1660 Print System, where print jobs of all supported emula-
tions can be received simultaneously. ESP technology examines the
first part of each print job to determine its emulation. Once the emula-
tion is identified, the print job processes without further checking. This
minimizes any slowdown resulting from the sensing process. To help
ESP technology determine the proper emulation of successive print
jobs, the printer must be able to identify the end of job for each job.
Therefore, unless a wait timeout (the amount of time the printer is
waiting on data from the host) occurs and ends each print job, or
unless you add an EOD command between each file being printed
through these protocols, some print jobs may be interpreted by the
printer as one job and may "run" together. See chapter 4,"Printer Con-
figuration," for more information on emulation timeout.
256 KB
36 KB
128 KB
12288
1026716
89940
936776
11" x 17"
600