QMS 1660 Reference Manual page 197

After you have accessed the Administration/Disk Operations menu,
press the control panel keys in the order shown in the following table.
The printer responds by displaying a status message in the message
window (DSK refers to the hard disk number, and CAR0 and CAR1
refer to the font or card number).
» Note: You may need to press the Next key one or more times to
advance through the list of selections or options.
Key Purpose
Select Accesses the Administration/Disk
Operations/Remove Option menu.
Select Accesses the Remove Option/Dsk#:
menu.
Next Scrolls through the list of attached
disks.
Select Selects the disk and accesses the card
address from which removal information
is being read.
Select Prompts you to insert the font card in
one of the card slots below the printer's
media cassette.
Begins reading data from the card and
removing the appropriate fusiform the
hard disk This usually takes several
minutes.
Acknowledges completion of the
installation process.
Menu Exits from the Install Option menu nd
returns to the Disk Operations menu.
After the option is removed, remove the card from the slot and place
the printer back on line.
Optional emulations, such as LN03 and QUIC II, are available as
PostScript files on PC floppy disks. This section describes how to
Message
DISK OPERATIONS
REMOVE OPTION
REMOVE OPTION
DSK#: x
REMOVE OPTION
DSK: x
REMOVE SOURCE
CAR#: x
REMOVE OPTION
INSERT MEDIA
REMOVE OPTION
READING DATA...
REMOVE OPTION
REMOVE COMPLETE
DISK OPERATIONS
REMOVE OPTION