Sirius XM RAdio OnyX User Manual page 39

Vehicle Installation
7. Ensure Onyx is tuned to channel 1,
the XM Preview channel . Upon power
up, Onyx should tune to channel 1 by
default, when it's not yet activated . If
it's not on channel 1, refer to "Listening
to Satellite Radio" on page 49 to
learn about how to tune a channel .
8. Turn on your vehicle's stereo system .
Set it to play from the auxiliary input
source . You should hear XM channel 1
through your vehicle's stereo system .
You are now ready to activate your
Onyx .
9. Go back to "Step 2: Install the Dash or
Vent Mount" on page 13 and finish
installing the Dash or Vent Mount .
Then the installation is complete .
10. The audio level output of Onyx can be
increased or decreased as necessary
to match the audio levels of other
sources in your vehicle . Refer to "Set
Audio Level" on page 69 .
If the signal reception is good, showing at least two bars in the lower left
corner of the display, but there is no XM audio, be sure the vehicle's stereo
system is set to the cassette source (step 4) . Also be sure that the audio
level is set high enough to be heard (step 5) . Refer to "Troubleshooting" on
page 79 for additional help .
1
866-635-2349
siriusxm.com
Signal Indicator
SATELLITE
TERRESTRIAL
XM Preview
39