Step 5: Connect The Magnetic Mount; Antenna And Powerconnect Power - Sirius XM RAdio OnyX User Manual

Vehicle Installation
towards the front of the vehicle . Use a blunt plastic putty knife or
similar blunt tool to lift the plastic trim just enough to tuck the cable
under underneath . Avoid side airbag locations on back pillars and
above the doors . Airbag locations are marked with "SRS" logos . Be
careful not to crimp or cut the cable .
4. Bring the cable out from the trim near the front of the cabin and route
it under the carpet toward the dashboard or console . Coil any excess
cable in a hidden location, such as under the carpet, keeping it away
from any vehicle pedals or controls . Secure the excess cable with wire
ties (purchased separately) .
5. Bring the end of the cable out at the PowerConnect Vehicle Dock
location . Leave yourself enough cable so you can easily connect it to
the antenna connector of the dock .
6. Continue with "Step 5: Connect the Magnetic Mount Antenna and
PowerConnect Power Adapter" on page 34 .
Pickup Truck
1. Use a blunt plastic putty knife or similar
blunt tool to lift the rubber molding
around the windshield and tuck the
antenna cable underneath it .
2. Continue tucking the cable underneath
the windshield molding around the
windshield to the lowest corner .
3. At the lowest corner of the windshield,
route the cable out of the windshield
molding and into the rubber weather
32