Turning The Key Tone On And Off; Using The Key Lock; Cloning The Programmed Data - GRE PSR-100 Owner's Manual

TURNING THE KEY TONE ON AND OFF

The scanner is preset to sound a tone each time you press one of its keys
(except ). You can turn the key tone off or back on.
1. If the scanner is on, turn OFF/VOLUME counterclockwise until it clicks to
turn it off.
2. Turn OFF/VOLUME clockwise to turn the scanner on. Welcome message
appears.
3. While Welcome message appears, press 1 to turn on the key tone or 2 to
turn it off.

USING THE KEY LOCK

Once you program your scanner, you can protect it from accidental program
changes by turning on the keylock feature. When the keypad is locked, the
only controls that operate are LIGHT, VOLUME, and SQUELCH.
Note: The keylock does not prevent the scanner from scanning channels or
monitoring a single channel, whichever feature you last selected.
To turn on the keylock, hold down
beeps three times and
seconds until the scanner beeps three times and

Cloning the Programmed Data

You can transfer the programmed data to and from another PSR-100 (or PSR-
200) scanner using an optional connecting cable with 1/8-inch (3.5mm) stereo
phone plugs on both ends (not supplied).
1. Turn on both scanner.
2. Connect the connecting cable to each scanner's PC/IF jack. CLOnE and
UP to SEnd appears.
3. Press at the host scanner.
4. SEndInG appears at the host scanner.
The scanner sends the data. To exit the clone mode, remove the cable.
CLOnE and Error may alternately appear when the scanner receives data from
a scanner other than a PSR-100/200. If this happens when the scanner re-
ceives data from another PSR-100/200, turn off the scanner and then turn it on
again.
28
for about 3 seconds until the scanner
appears. To turn it off, hold down for about 3
disappears.