Advertisement
Installation
Important: Please use the installation procedure below. Improper or no
operation may result if the start-up sequence is not correctly followed.
Step 1
Carefully unpack the contents of the shipping group.
Step 2
With system power turned off, connect the Transmitter module to the VGA D-
sub of PC or other video source equipment by a VGA copper cable. If
necessary, connect the RS232 cable plugs to each D-sub 9-pin connector on
PC and Transmitter module. Also if you use a Local monitor, connect HD-15
VGA connector.
Step 3
Connect the Transmitter module to the audio source equipment by audio
cables such as Stereo Phone Jack.
Figure 2 – Connection of VGA, AUDIO, RS232 Cable to Transmitter Module
1-3 Installation
Step 4
In the same way as above, connect the Receiver module to the display by
VGA copper cable and to the audio output equipments such as media
receiver or speaker by audio cable. The RS232 devices near the display can
be connected by RS232 copper cable also.
Figure 3 – Connection of Receiver Module
Step 5
Remove dust covers and connect two (2) duplex LC fibers to LC receptacles
of the Transmitter and Receiver modules, as shown in Fig. 4. Carefully ensure
the duplex LC connector is fully engaged.
Figure 4 – Connection of Two (2) Duplex LC Optical Fibers
1-4 Installation (continued)
Advertisement
