Sun Microsystems Sun Fire V40z User Manual page 162

Hide thumbs Also See for Sun Fire V40z:
Table of Contents

Advertisement

7. Route the new SCSI signal cable along the chassis wall, behind CPU 0 DDR
VRM (see
8. Continue routing the new SCSI signal cable between SCSI connector A and
the power-supply cage connector (see
9. Continue routing the new SCSI signal cable parallel with the horizontal PCI
slot, then fold it over the top of the LSI MegaRAID card that is installed in the
riser (see
10. Plug the end of the new SCSI signal cable, labeled "SCSI CNTRLR BOARD,"
into the LSI MegaRAID card rear SCSI connector (channel 0) (see
11. Reinstall the power-supply cage assembly.
Refer to
page
Ensure that the new cable does not obstruct the power-supply cage connector on
the motherboard before locking the cage in place.
12. Manually fold over the top of the new SCSI signal cable where it runs next to
the power-supply cage to provide clearance for reinstalling the rear fan-cage
assembly.
13. Reinstall the rear fan-cage assembly.
Refer to
Ensure that the fan cage does not bind the SCSI signal cable when you install the
cage.
14. Before reinstalling the cover on the server, check the routing of all cables for
obstructions.
4-24
Book Title without trademarks, or an abbreviated book title • January 2007
).
FIGURE 4-10
).
FIGURE 4-10
Section 4.5.9.2, "Replacing a Power-Supply Cage Assembly" on
4-44.
Section 4.5.8.4, "Replacing the Rear Fan-Cage Assembly" on page
).
FIGURE 4-10
).
FIGURE 4-10
4-40.

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Sun Fire V40z and is the answer not in the manual?

This manual is also suitable for:

Sun fire v20z

Table of Contents