Table of Contents
Advertisement
VideoJet X20 SN
8.8
Communication with Terminal Program
8.8.1
Data Terminal
If a VideoJet X20 SN cannot be found in the network or the connection to the network is
interrupted, you can connect a data terminal to the VideoJet X20 SN for initial setup and
setting of important parameters. The data terminal consists of a computer with a terminal
program.
You require a serial transmission cable with a 9-pin Sub-D plug to connect to the computer
and open ends for connection to the terminal block of the VideoJet X20 SN (see
Section 8.7.1 Pin Assignment, page 116).
HyperTerminal, a communications accessory included with Microsoft Windows, can be used
as the terminal program.
NOTICE!
i
Information on installing and using HyperTerminal can be found in the manuals or in the online
help for MS Windows.
1.
2.
8.8.2
Configuring the Terminal
Before the terminal program can communicate with the VideoJet X20 SN, the transmission
parameters must be matched. Make the following settings for the terminal program:
–
–
–
–
–
8.8.3
Command Inputs
After the connection has been established, you must log onto the VideoJet X20 SN to access
the main menu. Other submenus and functions can be accessed using the on-screen
commands.
1.
2.
3.
Bosch Security Systems
Disconnect the VideoJet X20 SN from the Ethernet network before working with the
terminal program.
Connect the serial interface of the VideoJet X20 SN using any available serial interface on
the computer.
19,200 bps
8 data bits
No parity check
1 stop bit
No protocol
If necessary, turn off the local echo so that entered values are not repeated on the
display.
Enter one command at a time.
When you have entered a value (such as an IP address), check the characters you have
entered before pressing Enter to transfer the values to the VideoJet X20 SN.
Installation and Operating Manual
Appendix | en 117
V3.5 | 2007.12
Advertisement
Table of Contents
