Station Call Forward Procedures - Toshiba DP5000-Series User Manual

Station Call Forward Procedures

Table 15 on Page 107
Forward function by entering the button sequence as described or by programming a
Programmable Feature Button to perform the sequence. See
Buttons" on page 86
To use the Call Forward button sequence
Follow the instructions in
Sequence" heading. Some features require additional input, such as:
• Dest. Ext. or Telephone No. – Call Forward destination numbers can be
internal extension numbers or outside telephone numbers. If the destination is
an outside number, enter the access code used for dialing out (such as
telephone number +
• Timer – Enter the number of seconds (08~60) your telephone should ring
before forwarding the call. (This is the Call Forward-No Answer timer.)
• Call Forward Pass Code – A four-digit Call Forward pass code can be setup
by your System Administrator and will allow one station to activate the call
forward setting for another station. Users must enter the Call Forward pass code
for the station to be forwarded.
Note In Table 15 on Page
confirmation tone and will play at that point in the sequence to confirm your
input was accepted.
Strata CIX DP5000-series Telephone UG
contains Call Forward Button sequences. You can do a Call
to program a Programmable Feature Button.
Table 17 on Page
#
. The CIX accepts destination numbers of up to 32 digits.
107, (tone) refers to three short tones used as a
11/08
"Programming Feature
112, shown under the "Button
Feature Operations
Call Forward
9
) + the
35