Table of Contents
Advertisement
Canopy T1/E1 Multiplexer
Status LEDS
The status indicator LEDS on the front of the Canopy T1/E1 Multiplexer are listed in
Table
3.
LED
PWR
RDY
CANOPY LINK
CANOPY ACT
LAN LINK
LAN ACT
T1/E1 Sync
1.2.6
Features
The Canopy T1/E1 Multiplexer
◦
installs easily.
◦
multiplexes up to 4 T1 or 3 E1 circuits onto a Canopy Backhaul point-to-point
link.
◦
enables T1/E1 extension over Ethernet networks.
◦
supports
−
synchronous TDM-based services over wireless Ethernet networks.
−
CAS signaling transparent to all other signaling protocols on T1/E1.
−
10Base-T/100Base-TX uplink to the network.
−
management interfaces.
−
simplified troubleshooting through T1/E1 line loopback test.
Issue 1
Table 3: LED status indicator descriptions
LED indicator descriptions
ON when main power supply is OK; OFF when a malfunction is
detected
ON when self-test is successfully completed; OFF during self-test; and
BLINKING when self-test fails
OFF when line is not active; ON when Canopy BH Ethernet line is OK
OFF when no activity; BLINKNG when frames are being transmitted or
received on the line
OFF when line is not active; ON when line is OK
OFF when no activity; BLINKING when frames are being transmitted or
received on the line
ON when the port is synchronized (no alarm); OFF when Loss of signal
(LOS); one LED for each T1/E1
T1/E1 Multiplexer Release 3.1
June 2004
14 of 69
Page
Advertisement
Table of Contents
