Canopy T1/E1 Multiplexer
1.3
CONFIGURATION SETTINGS FROM CANOPY FACTORY
1.3.1
Bit Handling Capability
As shipped, Canopy T1/E1 Multiplexers transparently pass all T1 or E1 bits regardless of
◦
user framing as
−
D4
−
Extended Superframe (ESF)
◦
user encoding as
−
AMI
−
B8ZS
−
HDB3
However, user encoding is helpful for generating meaningful bipolar variation (BPV) data.
Canopy T1/E1 Multiplexers are factory preset to the B8ZS encoding for T1, though easily
changed to another encoding scheme, and are preset as master or slave for timing.
NOTE: To receive the highest level of performance from these units, the user should
understand
◦
clock recovery timing.
◦
packet/frame loss concepts.
◦
delay and latency.
◦
jitter.
1.3.2
License Keys
Each Canopy T1/E1 Multiplexer is purchased and shipped as 1-port enabled or 4-port
enabled. You can upgrade any pair of 1-port enabled Canopy T1/E1 Multiplexers through
the purchase and installation of
◦
two keys, one per unit, to transform both to 2-port enabled.
◦
four keys, two per unit, to tranform both to 3-port enabled.
◦
six keys, three per unit, to transform both to 4-port enabled.
1.3.3
Power Adapters
For connection to power sources, the 110-volt power supply pictured in
Page
12
and the global adapter set pictured in
purchase of each Canopy T1/E1 Multiplexer. The −48 v screw-down adapter for battery
backup pictured in
1.4
PRODUCT LABELS
Labels on the Canopy T1/E1 Multiplexer include
◦
ESN — Electronic Serial Number, the Media Access Control (MAC) address
◦
MSN — Model Serial Number, which allows tracking of the product
◦
Factory Configuration, which identifies the product as
−
Master Unit or Slave Unit
−
1-Port Unit or 4-Port Unit
Issue 1
Figure 6
on Page
12
T1/E1 Multiplexer Release 3.1
Figure 5
on Page
is an option.
June 2004
Figure 4
on
12
are included with the
17 of 69
Page