Table of Contents
Advertisement
Canopy T1/E1 Multiplexer
2.2.2
2.2.2
Preparing for Installation and Setup
Preparing for Installation and Setup
The Canopy Ethernet cable for the port plugs directly into the Canopy T1/E1 Multiplexer.
The Canopy Ethernet cable for the port plugs directly into the Canopy T1/E1 Multiplexer.
The LAN Ethernet port cable is a straight-through cable between the Canopy T1/E1
The LAN Ethernet port cable is a straight-through cable between the Canopy T1/E1
Multiplexer and the Ethernet switch.
Multiplexer and the Ethernet switch.
To connect the Canopy T1/E1 Multiplexer to a PBX, a T1/E1 crossover cable is likely
To connect the Canopy T1/E1 Multiplexer to a PBX, a T1/E1 crossover cable is likely
required. Refer to your PBX installation instruction manual for specific requirements.
required. Refer to your PBX installation instruction manual for specific requirements.
2.2.3
2.2.3
Mounting the Canopy T1/E1 Multiplexer
Mounting the Canopy T1/E1 Multiplexer
Mounting option for the unit is either a desk mount or a rack mount. Follow this procedure
Mounting option for the unit is either a desk mount or a rack mount. Follow this procedure
to affix the until to a rack mount:
to affix the until to a rack mount:
Procedure 1: Affixing the Multiplexer to a rack mount
Procedure 1: Affixing the Multiplexer to a rack mount
1. Remove the Front Panel by removing Front Panel Mounting Screws.
1. Remove the Front Panel by removing Front Panel Mounting Screws.
2. Remove the two screw posts from the DB-9 connector.
2. Remove the two screw posts from the DB-9 connector.
3. Remove Front Bezel and set aside.
3. Remove Front Bezel and set aside.
4. Place the Canopy T1/E1 Multiplexer behind the desired Rack Panel mounting
hole.
NOTE: The Rack Panel will support three (3) Canopy T1/E1 Multiplexers.
5. Place the Front Panel on the front of the Rack Panel opening, positioning the
Rack Panel Spacer between the two panels.
6. Insert the front panel mounting screws through the screw holes.
7. Tighten screws.
8. Insert the screw posts onto the DB-9 connector.
9. Tighten screw posts.
10. Mount the Canopy T1/E1 Multiplexer with the rack panel onto your rack unit.
Consult the product information supplied by the rack manufacturer for details.
NOTE: The front panel mounting screws should be 4-40 screws, between 3/8"
and 5/8" long.
Issue 1
Figure 12: Front panel and front bezel removed
end of procedure
T1/E1 Multiplexer Release 3.1
June 2004
27 of 69
Page
Advertisement
Table of Contents
