Table of Contents
Advertisement
Canopy T1/E1 Multiplexer
Action
Set LAN-side Ethernet
auto-negotiation
Log off
Procedure 11: Configuring the T1 ports using the CLI
Follow this procedure to configure the T1 ports from the CLI manager.
Action
Log in
Set T1 line length
Issue 1
Enter set lan port auto negotiation [on/off]
where
on enables auto negotiation at 100 Mbps Full Duplex (as default).
off forces the port to 100 Mbps Full Duplex without auto negotiation.
RESULT: The system responds
LAN port auto-negotiation is: on
Enter lo.
RESULT: The system responds goodbye.
end of procedure
Press Enter.
At the username prompt, enter admin.
At the password prompt, enter password.
NOTE: If the incorrect line length is selected, the result could be decreased
T1 quality or echo on voice lines. The default length is 133 ft.
Enter
set line [1/2/3/4] length [133, 266, 399, 533]
where
[1/2/3/4] represents T1 ports 1 through 4.
[133, 266, 399, 533, 655] represents line length in feet.
RESULT: The system responds
Line [1/2/3/4] length
dB; 266-399 / 1.8 dB; 399-533 / 2.4 dB; 533-655 / 3.0
dB]
T1/E1 Multiplexer Release 3.1
Steps
Steps
[0-133 / 0.6 dB; 133-266 / 1.2
June 2004
37 of 69
Page
Advertisement
Table of Contents
