Canopy T1/E1 Multiplexer
The recommended sequence of connection is:
1. Connect a PBX or TDM CPE to the T1/E1 port(s). (See
2. Connect the Ethernet cable from the Canopy Backhaul Module to the jack
labeled Canopy. (See
3. Connect the selected power adapter to the T1/E1 Multiplexer. (See
Figure
4. Power the T1/E1 Multiplexer on. (See
5. As required to configure the T1/E1 Multiplexer, connect a PDA or notebook
computer to the jack labeled CONTROL on the front panel of the T1/E1
Multiplexer. (See
1.2.5
Front Panel
The control port and indicator LEDs are located on the front panel of the unit.
Issue 1
Figure 3
5.)
Figure
7.)
Figure 7: Canopy T1/E1 Multiplexer front panel
T1/E1 Multiplexer Release 3.1
on Page 11.)
Figure
4.)
June 2004
Figure 3
on Page 11.)
Figure 4
and
13 of 69
Page