Antari M-1 User Manual

Antari M-1 User Manual

Mobile fog machine
Hide thumbs Also See for M-1:

Advertisement

Quick Links

User Manual for the Antari M-1 Mobile Fog Machine
Congratulations on the purchase of your new
ANTARI M-1 Mobile Fog Machine
Save and read these instructions
Bitte lesen Sie und sichern Sie diese Anweisungen
Lisez et Gardez ces instructions
© 2007 Antari Lighting and Effects Ltd.

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the M-1 and is the answer not in the manual?

Questions and answers

Summary of Contents for Antari M-1

  • Page 1 User Manual for the Antari M-1 Mobile Fog Machine Congratulations on the purchase of your new ANTARI M-1 Mobile Fog Machine Save and read these instructions Bitte lesen Sie und sichern Sie diese Anweisungen Lisez et Gardez ces instructions © 2007 Antari Lighting and Effects Ltd.
  • Page 2 Antari M-1 Fog Machine Danger of Electric Shock Keep this device dry. Always remove the battery or unplug the power adaptor to your Antari M-1 Fog Machine before filling the liquid tank. Keep fog machine upright. Remove the battery or unplug the power adaptor when not in use.
  • Page 3: Danger Of Explosion

    Fog machine output is hot. Avoid coming within 50 cm of the output nozzle during operation. Place the fog machine in a well-ventilated area. Never cover the vents on the front of the M-1. Never aim the output nozzle at open flames.
  • Page 4: Operation

    To stop fogging, press the button again. Use the small switch on the right side of the M-1. The switch is inside the case and is adjusted through the small hole on the side of the case.
  • Page 5: Installation

    When an optional remote is connected, please see the detailed instructions for their operation below. The machine will fo until the battery charge runs down or the M-1 runs out of fog liquid. When the M-1 is connected to the optional power adaptor, carefully monitor the level of the fog liquid to make sure the machine does not run out of liquid.
  • Page 6: Performance Notes

    After continuous operation, the case of the fog machine will become warm, especially at the front of the machine. Take care in handling the machine during and shortly after fogging. Only carry the M-1 Mobile Fogger by the handle and let the machine cool down before packing it in a carrying case.
  • Page 7 油桶容量: 110 c.c. 電池規格: 直流 12V /2.3Ah 耗油速率: 2c.c./每分鐘 適用煙霧水: Antari FLM-05 煙霧水 選購控制器: MCT-1 (定時線控器) MCR-1 (無線搖控器) 重量: 1.8 公斤(M-1 機身及電池) 5.5 公斤(M-1 含飛行箱,電池,充電器及 500c.c.煙霧水一罐) 尺寸(mm): 長 227 寬 66 高 81 持續輸出時間: 10~12 分鐘(使用電力飽滿的電池) 無限制(使用假電池和變壓器組,只要提供充足的煙霧水) 請保持機器乾燥。 在填充煙霧油至油桶之前,請先拆下 M-1 煙霧機的電池或拔掉機器電源插頭。...
  • Page 8 機器僅限成人使用,放置煙霧機之地點應避免兒童可及之處,機器使用中請時常注意機器狀況。 煙霧機所產生的煙霧溫度較高,機器運作時,請遠離噴嘴 50 公分以上。 請勿將機器噴嘴對著人體及動物直射。 請將煙霧機放置於通風良好的地方,請勿遮蓋機器散熱部分,並勿將機器噴嘴對準火舌。 當機器運作時,噴嘴輸出部分之溫度非常高,故請將任何物品放置遠離機器 50 公分以上。 清潔、從事維護及收納機器時,請先確認機器已經完全冷卻。 請勿將電池暴露在高溫下,遠離火舌並請勿任意在機器操作時,拆卸零件。 請勿將任何可燃性液體( 如油脂, 瓦斯, 香水),放置於煙霧油槽中,並在使用前詳細閱讀說明書。 請使用代理商所推薦的 Antari 高品質 FLR / FLG 水性煙霧油(M-1 只使用 FLM-05 煙霧油),若任意 使用其他煙霧油,將可能導致堵管現象甚至造成內部零件腐蝕。 請確認煙霧油槽中有足夠的煙霧油,以免造成煙霧機幫浦空轉過熱。 若在無填裝煙霧油的狀態下運轉機器,將導致幫浦與加熱管的損壞。 若您的 Antari M-1 機器有任何不當運轉情況時,請即刻停止使用,倒出煙霧油,等機器冷卻後, 仔細包裝好本產品(建議以原包裝) 送至代理商或經銷商處維修。 請記得在運送或郵寄本產品前,確定完全傾倒出所有在油桶中的煙霧油。 煙霧油不能飲用,誤飲時,如有任何不適請立即就醫,若不甚接觸眼睛,請即刻以水清洗。 建議: 在使用本機器之前,詳細的閱讀一次印刷在機器上蓋板及後背板的警語標示。 請打開包裝確認機器運作的所有設備齊全,請參考配置圖,確認您所購買的機型應包括之項目,倘若 有缺少任何項目,請即刻聯絡 Antari 經銷商。機器出廠時應包含以下物件:...
  • Page 9 充完電後約能連續使用 10~12 分鐘。 電池安裝至機器時,請注意方向(貼紙面朝上-如圖示)。 放置電池時請稍微傾斜機器,會更容易置入,銀色卡榫為固定電池之用。 請確認電池放置時的位置正確(如附圖)。 當第一次按下按鈕時,機器把手前方的綠燈會閃爍,表示電池已經充電飽和。 當紅色燈開始閃爍時,表示電池需要充電,但這時機器仍能稍微運作一陣短暫時間。 啟動噴煙動作的開關位於機器提把的上方有兩種操控方式可選擇,請注意 M-1 機身右側有一個開 孔,開孔中有一個小開關,可利用此小開關來切換操作模式。 操作模式 1: 將右側孔中的小開關往油桶蓋方向撥,可將機器設定在一號操作模式,在此模式下, 持續壓著把手上的開關,M-1 會持續噴煙動作,而一旦鬆開開關,機器就會停止噴煙。 操作模式 2: 將右側孔中的小開關往噴嘴方向撥,可將機器設定在二號操作模式,在此模式下,按 一下把手上的開關,M-1 就會開始持續噴煙,只要再按一下把手開關即可停止機器噴煙。 機器可持續噴煙直到電池電量使用完或煙霧油使用完。當 M-1 連接上電源插頭時,請小心注意勿 讓機器在煙霧油秏盡時仍繼續運作。機器油桶中的煙霧油,大約可連續提供機器使用 50 分鐘。 當充電完畢,電量飽滿的電池可以提供 M-1 機器連續 10~12 分鐘的運作, M-1 機器並不須要預熱時間,不同於其他煙霧機,在使用 M-1 時不須要事先預熱。 煙霧機可提供隨時攜帶或放置固定位置運作的兩種需求。 當機器安置並運作時,請注意勿朝向人們臉部噴射,並勿任意放置在易燃物品旁邊。 此機器可以裝置於各種角度,在重覆裝填煙霧油時,請牢固地旋緊油桶蓋。...
  • Page 10 1. MCT-1 定時控制器: 此控制器是透過一條總長 8 公尺的電線與 M1 連接,內建設定的持續 煙霧輸出為 10 秒 , 而每次煙霧的輸出間距可透過控制器上的旋鈕來設定於 3 至 220 秒之間 。 2. MCR-1 無線控制器組:將無線控制器組的訊號接收器安裝上 M1,可利用發射器來控制噴煙 動作,發射訊號的有效距離在空曠處最遠可達 50 公尺。 選配的假電池及電源變壓器組 您可以選購 M-1 假電池和電源變壓器組(品號 DCP-12) 電源變壓器組適用於交流 100~240V 的電源,可轉換為直流 12V 的電壓並透過假電池來供 應 M-1 動作所需的電力,雖然使用時的行動力不若使用電池般的不受到電源插座和電源線的 空間限制,但可滿足長時間工作的需求,不必擔心電力耗盡的問題。 若 M-1 機器需要閒置超過一個小時以上請移出電池,否則電池將容易故障。將機器放回飛...
  • Page 11 機器不使用需收納之前請先清潔機器並確定將油桶清空,拆下控制器與電源線收好,整套 機器與配件請存放於乾燥陰涼處,每月固定溫機一次,可保護機器較不受潮。...
  • Page 12 C08M01001...

Table of Contents