Table of Contents
Advertisement
Table of Contents
SETUP AND REFERENCE
Insert the Batteries ..............................................................S-1
Making the Remote Work with Your Receiver...................S-1
Program the Remote to Control Your TV...........................S-2
Placing Your Remote in Limited Mode...............................S-3
Operation
If You Lose Your Picture......................................................S-3
SAT Mode..............................................................................S-4
TV Mode................................................................................S-5
VCR Mode.............................................................................S-6
IN THIS GUIDE
Remote Control Overview ...................................................... 1
Using the Guide ...................................................................... 1
Remote Control Modes .......................................................... 1
How the Remote Communicates........................................... 2
Programming for Other Equipment ...................................... 2
Combination Equipment (for example, TV/VCR) ..........2
Limited Mode ...................................................................2
Programming Using Equipment Code Tables ..............3
Scanning for Equipment Codes .....................................4
Control...........................................................................6
in AUX Mode .................................................................7
Reading Out the Remote Control Codes .............................. 8
Discrete Codes for Learning Remotes ................................. 9
Equipment Codes ................................................................. 10
Troubleshooting.................................................................... 18
Limited Warranty................................................................... 19
Your Remote Control Codes ..................... Inside Back Cover
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the Remote Control and is the answer not in the manual?
Questions and answers
How do I open door to system info
Power went out. Blue screen says to hold “OK” button for three seconds. My remote doesn’t have an “OK” button. What do I do?
How do I change the secondary remote channel (TV2) so both remotes are have the same channel. I have two remotes and want them both using the same tv from different rooms.
To change the secondary remote channel for a Dish Network remote so both remotes control the same TV, follow these steps:
1. Turn on the receiver and display the System Info screen (refer to the receiver user guide if needed).
2. Write down the remote address shown on the screen.
3. Press and hold the AUX button on the remote until all mode buttons light up, then release it. The AUX button should flash.
4. Press the "3" button on the number pad.
5. Enter the remote address you wrote down in step 2 using the number pad.
6. Press the POUND (#) button. The AUX button should blink three times.
7. Press the RECORD button to confirm that the remote is programmed to match the receiver.
Now both remotes should be set to the same address and control the same TV.
This answer is automatically generated
this does not look like my remote and how do I go fast forword ive ony been able to go 30 sec or 15 times
To fast forward using the Dish Network remote control, press and release the fast-forward button to skip forward through recorded programs. To fast-forward quickly (x4 speed), press and hold the button before releasing. If you press and release the button once while in fast-forward mode, the speed increases to x60.
This answer is automatically generated
how do you search using the new remote
You can search using the DISH Network remote control by using voice commands. With DISH Voice Remotes, simply say what you want, such as:
- "Tune to ESPN" to watch ESPN.
- "Free previews" to open the Free Preview Showcase menu.
- "Play," "Pause," or "Fast Forward" to control playback.
Make sure you are in SAT mode by pressing the SAT Mode button before using these features.
This answer is automatically generated
Where is the control menu button