Table of Contents
Advertisement
Instructions
7
Press POUND (#).
8
Press POWER to turn off
the equipment. If the equip-
ment does not turn off, go
to step 10.
9
Turn the equipment back
on and try some other but-
tons to make sure they
work. If the code works for
other buttons, stop here.
10
If the code doesn't work,
redo steps 3 through 9 with
another equipment code
from the tables.
11
If you can't find a code that
works, try Scanning for
Equipment Codes that
follows.
S
CANNING FOR
Instructions
1
Turn the equipment on.
2
Press and hold the mode
button until all the other
mode buttons light up, and
then let go of the button.
The mode button flashes.
4
E
QUIPMENT
Additional Information
If you entered the code
correctly, the mode button
flashes three times.
If the code works, the
equipment should turn off.
For example, sometimes
POWER works when other
buttons don't.
Try every code listed for your
brand until one works for your
equipment.
C
ODES
Additional Information
Use the equipment's front panel
buttons or its remote control.
For example, hold TV for a TV
until all of the other mode
buttons light. When you let go,
TV will flash.
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the Remote Control and is the answer not in the manual?
Questions and answers
How do I open door to system info
Power went out. Blue screen says to hold “OK” button for three seconds. My remote doesn’t have an “OK” button. What do I do?
How do I change the secondary remote channel (TV2) so both remotes are have the same channel. I have two remotes and want them both using the same tv from different rooms.
To change the secondary remote channel for a Dish Network remote so both remotes control the same TV, follow these steps:
1. Turn on the receiver and display the System Info screen (refer to the receiver user guide if needed).
2. Write down the remote address shown on the screen.
3. Press and hold the AUX button on the remote until all mode buttons light up, then release it. The AUX button should flash.
4. Press the "3" button on the number pad.
5. Enter the remote address you wrote down in step 2 using the number pad.
6. Press the POUND (#) button. The AUX button should blink three times.
7. Press the RECORD button to confirm that the remote is programmed to match the receiver.
Now both remotes should be set to the same address and control the same TV.
This answer is automatically generated
this does not look like my remote and how do I go fast forword ive ony been able to go 30 sec or 15 times
To fast forward using the Dish Network remote control, press and release the fast-forward button to skip forward through recorded programs. To fast-forward quickly (x4 speed), press and hold the button before releasing. If you press and release the button once while in fast-forward mode, the speed increases to x60.
This answer is automatically generated
how do you search using the new remote
You can search using the DISH Network remote control by using voice commands. With DISH Voice Remotes, simply say what you want, such as:
- "Tune to ESPN" to watch ESPN.
- "Free previews" to open the Free Preview Showcase menu.
- "Play," "Pause," or "Fast Forward" to control playback.
Make sure you are in SAT mode by pressing the SAT Mode button before using these features.
This answer is automatically generated
Where is the control menu button