Restoring The Factory Default Settings - Lionel AMC/ARC Gantry Crane Owner's Manual

restoring the factory default settings

F
ollow these steps to reset the Gantry Crane to its factory defaults. The ID numbers and
voltage settings will be reset.
1. Remove the jumper from the underside of the controller. Refer to Figure 5 on page 8 for
the location of the jumper.
2. Turn off power to the Gantry Crane.
3. Pull the three levers down towards the front of the controller.
4. While holding the three levers down, turn on power to the Gantry Crane. The LED flashes
once.
5. Release the levers. At this point, the LED will flash.
6. Replace the jumper, and the Gantry Crane is reset.
11