Mira Elevate Installation And User Manual page 13

. Fit the wall bracket into the top
bracket of the slide bar.
. remove the backing from the sticky
pad on the rear of the wall bracket.
3. Fit the front cover of the shower onto
the backcase.
with the front cover pushed fully
into place, apply a small amount of
pressure to the top bracket. this will
allow the sticky pad to hold the wall
bracket in position ready for marking
the position of the fixing holes.
4. carefully remove the front cover
making sure that the wall bracket is
in place on the wall.
15. Mark the positions of the fixing holes
and drill the fixings holes with a
suitable drill and install the wall plugs.
secure the wall bracket to the wall
with the screws provided.
16. Refit the service tunnel.
7. refit the cover assembly. Make
sure that it fits correctly. Fit the three
screws to secure the cover assembly
in position.
note! the fourth cover screw is used
to secure the soap dish in position
and will be fitted at a later stage.
8. Fit the screw to secure the top
bracket assembly in position.
Do not use alternative screws to
secure the cover. this can cause
internal damage to the appliance.
Do not seal around the back of
appliance.
sticky Pad
wall Bracket
3
top Bracket
top Bracket
case
assembly