Installation - Mira Elevate Installation And User Manual

Warning! turn off the electrical and water supplies before proceeding with the
installation of the Mira Elevate. the electricity must be turned off at the mains and
the appropriate circuit fuse removed, if applicable.
. hold the installation template in the
required position on the wall and
mark the positions of the fixing holes.
Make sure that there is adequate
clearance available for the slide
bar.
note! Make sure that the position of
these holes do not come in line with
any buried cables or pipework. Make
sure that sufficient electrical supply
cable is available for connection to
the terminal block.
2. Drill the fixing holes with a suitable
drill and install the wall plugs.
3. holding the clamp bracket assembly,
squeeze the sides together and push
the clamp bracket into the groove in
the slide bar.
note! it is important that you slide
the shorter edge of the clamp bracket
onto the slide rail first.
4. Fit the top and bottom brackets to
the ends of the slide bar and secure
in position with the fixing screws.
note! Make sure that the hose clip
is installed correctly when you fit the
bottom bracket in position.

InsTaLLaTIon

Bottom
Bracket
0
top
Bracket
hanging hook/
hose clip
Fixing
screws
installation
template
Fixing
screws
clamp Bracket
assembly
slide Bar