Yaesu FTA-720 Operating Manual page 52

3. Power On Beep
Function: Selects the Power-on beep.
Available Values: Off/Mode 1/Mode 2/Mode 3
Default Setting: Mode 1
3. R
eceive
1. SQL
Function: Sets the Squelch threshold level for the AM
and FM Narrow modes.
Available Values: 0 - 8
Default Setting: 6
2. FM Radio SQL
Function: Sets the Squelch threshold level for the FM
BC Band.
Available Values: 0 - 8
Default Setting: 3
3. Resume
Function: Selects the Scan Resume mode.
Available Values: 5secs/Busy
Default Setting: 5secs
5secs: The scanner will hold for 5 seconds, then resume
whether or not the other station is still transmitting.
Busy: The scanner will hold until the signal disappears,
then will resume when the carrier drops.
50
( "s " ) m
m
enu et
4. DW/PRI
Function: Selects the Dual Watch/Priority Function.
Available Values: DW/PRI
Default Setting: DW
5. RX Save
Function: Selects the Receive-mode Battery Saver
"sleep" ratio.
Available Values: ABS/1:1/1:2/1:3/1:4/1:5/Off
Default Setting: ABS
The setting of "1:5" will promote the greatest conserva-
tion of battery capacity, but the receiver's response time
to incoming calls will be slowed somewhat.
ABS: Automatic Battery Saver, based on activity on the
receiver.
Note: This feature cannot be activated during Scan or
Dual Watch/Priority operation.
6. Step
Function: Setting of the synthesizer steps.
Available Values: 5k/10k/12.5k/15k/20k/25k/50k/100k
Default Setting: Depends on the operating band.
ode
FTA-720 O
perATing
M
AnuAl