Standby Power LED
This LED will lit red when the system is in the standby mode. It indicates that there is power
on the system board. Power-off the PC and then unplug the power cord prior to installing any
devices. Failure to do so will cause severe damage to the motherboard and components.
Chapter 2 Hardware Installation
Chapter 2
Front Panel Connector
Standby Power LED
HDD-LED - HDD LED
This LED will light when the hard drive is being accessed.
RESET SW - Reset Switch
This switch allows you to reboot without having to power off the system.
ATX-SW - ATX Power Switch
This switch is used to power on or off the system.
PWR-LED - Power/Standby LED
When the system's power is on, this LED will light. When the system is in the S1 (POS - Power
On Suspend) state, it will blink every second. When the system is in the S3 (STR - Suspend To
RAM) state, it will blink every 4 seconds.
HDD-LED
RESET SW
27
Front
Panel
Pin Pin Assignment
Pin Pin Assignment
3
HDD Power
2
LED Power
5
Signal
PWR-LED
4
LED Power
7
Ground
6
Signal
9
RST Signal
8
Ground
ATX-SW
11
N.C.
10
Signal
1
2
PWR-LED
HDD-LED
ATX-SW
RESET-SW
11
12
www.dfi .com