Adjustment And Operation - MK Diamond Products MK-770 series Owner's Manual & Operating Instructions

SETUP, ADJUSTMENT and OPERATION

ADJUSTMENT and OPERATION:

1. Cutting Straight Edges:
DO NOT FORCE THE TOOL. It will do the job better and safer at the rate for which it was
designed.
Turn counter-
clockwise to loosen
(A)
Loosen the Adjustable Cutting
Guide retaining thumbscrew
(D)
Place the tile against the
Ruler/Stop and Cutting Guide
Hold Work
in Position
Direction
of Cut
(G)
Perform the cut
MK-770
Position the Adjustable Cutting
Guide to desired cut length
indicated inside the diamond
Ruler/Stop On Position
Adjustable
ON/OFF
Cutting Guide
Switch
Turn the motor ON
ON/OFF
Switch
Turn the motor OFF when work
Revision 01/02, Effective Date January 10, 2002
Desired cut length
indicated here
(B)
(E)
Off Position
Shown
(H)
is complete
Turn clockwise
to tighten
(C)
Tighten the retaining
thumbscrew
Cooling Flow
Points
(F)
Verify cooling flow on both sides
of the blade (See Maintenance
Section to adjust flow)
Page 19