Assembly - MK Diamond Products MK-770 series Owner's Manual & Operating Instructions

UNPACKING, TRANSPORT, UNIVERSAL STAND and ASSEMBLY

ASSEMBLY:

Follow the assembly instructions to prepare your MK-770 for operation.
1. Cutting Head Installation:
NOTE: If the Cutting Head is installed, go to step 2.
Flat Washer
Height
Adjusting Knob
(A)
Place the Flat Washer onto the
Height Adjusting Knob
Turn Clockwise
(D)
Install the Height Adjusting Knob
through the Post into the Cutting
Head and tighten the Knob
2. Diamond Blade Installation:
NOTE: When installing the Retaining Screw, do not "cross-thread" and DO NOT over tighten the screw.
Blade Guard
Retaining Knob
(A)
Loosen and remove the Blade
Guard, Retaining Knob
MK-770
Post
Align Cutting Head Pivot Hole to
the Post, Pivot Shaft
to tighten
Turn counter-
Blade Guard
clockwise to Retaining Wingnut
loosen
Loosen the Blade Guard,
Retaining Wing nut
Revision 01/02, Effective Date January 10, 2002
Pivot Hole Completely
Pivot Shaft
(B)
completely installed and seated
Turn counter- Rotate clockwise
clockwise to
loosen
Blade
Guard
(B)
Installed
(C)
Verify the Cutting Head is
on the Post
to open
(C)
Open the Blade Guard
Page 13