Setup, Adjustment And Operation Setup - MK Diamond Products MK-770 series Owner's Manual & Operating Instructions

SETUP, ADJUSTMENT and OPERATION
SETUP:
1. Pre-start Inspection:
Prior to beginning work, a pre-start inspection of the saw should be performed.
ON/OFF
Switch
(A)
Ensure the ON/OFF Switch
is in the OFF position
Inspect for
cracks or cuts
Inspect for
damage
(D)
Inspect the Pump Assembly for
damage – ensure the cord is
free of cracks or cuts
2. Connecting the Water Pump:
To prevent the possibility of electrical shock, the MK-770 MUST be de-energized when
1.
connecting the Water Pump.
To prevent the possibility of electrical shock, use only MK Diamond qualified replacement
2.
parts
NOTE: To prevent pump damage, the Water Pump must be disconnected if cutting with a Dry Blade.
Inlet
connection
Cooling
Transfer
Tube
(A)
Connect the Cooling Transfer
Tube to the inlet connection of
the Blade Guard
MK-770
Verify ease of movement
(See Maintenance section
Off Position
if problems exist)
Verify the Movable Cutting
Table moves freely
Inspect for
damage
Inspect the MK-770 for
damage – ensure the cord is
free of cracks or cuts
Press on
Pump
Connection
Press
together
Connect the Water Pump power
cord to the connection found on
the back of the motor
Revision 01/02, Effective Date January 10, 2002
Inspect for cracks,
de-bonding, etc.
(B)
Inspect the Diamond Blade for
correct for the type of material
(E)
(B)
(C)
damage – verify the blade is
being cut
Page 16