MK Diamond Products MK-770 series Owner's Manual & Operating Instructions page 14

UNPACKING, TRANSPORT, UNIVERSAL STAND and ASSEMBLY
Motor Shaft
Motor
(D)
Place the Shaft Wrench
between the Inner Blade Guard
and the Motor and onto the
Motor Shaft
Turn clockwise
to tighten
Retaining nut and
Shaft
Outer Flange
Wrench
(G)
Install the Retaining Nut and
Outer Flange and then tighten
using the Blade and Shaft
Wrenches
Rotate clockwise
to tighten
Blade Guard
Retaining Wingnut
(J)
Tighten the Blade Guard
Retaining, Wing nut
MK-770
Inner Blade
Turn counter-
Guard
clockwise to
loosen
Shaft Shaft
Wrench Wrench
Using the Blade and Shaft
Wrenches, loosen and remove
the Retaining Nut and Outer
Blade Rotate counter-
Wrench clockwise to close
Blade
Guard
Close the Blade Guard
Rotate clockwise
to tighten
Tighten the Blade Guard,
Retaining Knob
Revision 01/02, Effective Date January 10, 2002
Retaining nut and
Outer Flange
Blade
Wrench
(E)
Flange
(H)
Blade Guard
Retaining Knob
(K)
Diamond
Blade
(F)
Install Diamond Blade
onto Blade Shaft
Rotation Direction
(I)
Verify the Blade is seated on
the Blade Shaft and direction
of rotation is correct
Blade
Shaft
Page 14