Securing The Drive - OWC Mercury Elite-AL Pro Owner's Manual

7. Look at the side of the drive enclosure. You will see the 2 holes
shown here, on each side of the enclosure. Fasten the drive into
the enclosure with the included Phillips screws here.
8. Closeup showing 2 screws installed on the left side. Repeat for
the right side. Make very certain that the screws are tight.
9. Set the top cover back onto the drive enclosure, sliding the
cover onto the enclosure in it's enclosed rail. Once the top cover
is fully closed, replace the 4 Torx T-10 screws from the back cover,
and the drive is ready to hook up to your computer for format-
ting. Attach the power cable, the interface cable of your choice,
and power the drive on.