Microtek ArtixScanDI 4020 Plus User Manual page 14

Notice for Calibration Data
It is strongly recommended that you should duplicate a copy of calibration data for your scanner
after installing the software in case if you loose the Microtek Software CD/DVD or a newer
version of ScanWizard DI is required in the future. You can find the calibration data in either of
these two locations:
• After the software has been installed, go to the drive where it is installed and look for a folder
named "Scanners". Double-click "Scanners" to open it, look for a data named
"ADFCalData86_xxxx.dat" for ArtixScan DI 4020 Plus or "ADFCalData87_xxxx.dat" for
ArtixScan DI 2020 Plus, and then copy it out from the folder.
• Look for the same folder "Scanners" in your Microtek Software CD/DVD, open it to look for
a data named as same as that mentioned above, and then copy it out from the folder.
14 ArtixScan DI 4020 Plus/ArtixScan DI 2020 Plus User's Manual