Regulator And Lp Cylinder Connections - Member's Mark BQ05051-3 Manual

Bubbles indicate a leak. In that case, call your LP dealer or fire department immediately.
TRANSPORTATION AND STORAGE
1. Place dust cap on cylinder valve outlet whenever the cylinder is not in use.
Only install the type of dust cap on the cylinder valve outlet that
is provided with the cylinder of Propane Valve. Other types of caps
or plugs may result in leakage.
2. Always transport in an upright position.
3. Do not smoke when transporting your cylinder.
4. Keep cylinders out of direct sunlight and away from sources of heat.
5. Cylinders must be stored outdoors out of the reach of children and must not be stored in a building,
garage, or any other enclosed area.

Regulator and LP Cylinder Connections

The gas pressure regulator provided with this outdoor cooking appliance must be used. This regulator is
set for an outlet pressure of 11 inches water column. Replacement pressure regulators and hose
assemblies must be those specified in the parts list.
Your regulator is equipped with a Q.C.C. Type 1 quick connect system. It will not allow gas to flow until a
positive seal has been made. It also has a flow-limiting device that will restrict the flow of gas to 10 cubic feet
per hour (0.28 cubic meters per hour).
TO CONNECT THE CYLINDER TO THE REGULATOR AND HOSE
1. Be sure the LP cylinder is "OFF" by turning the hand wheel clockwise
until it stops.
2. Place the cylinder into the drawer base of the grill with the valve
facing outward and secure with the cylinder support ring.
3. Be sure all burner controls are turned to the "Off" position.
4. Remove the safety cap from the from the cylinder valve.
5. Center the nipple of the regulator into the cylinder valve
6. Turn the black nut clockwise until it stops. Hand Tighten Only.
Do Not Use A Wrench.
!
DANGER
Dust Cap
!
CAUTION
16