Table of Contents
Advertisement
Assembly Instructions & User's Manual
for
Member's Mark 4 Burner Gas Grill
Item Number: 980304856 / 980302550
Model Number: GR2334401-MM-00
Customer Assistance
: 1-888-837-1380
(spare/replacement parts)
or Email: customerservice@rankam.com
THIS ASSEMBLY MANUAL CONTAINS INPORTANT SAFETY INFORMATION.
PLEASE READ AND KEEP FOR FUTURE REFERENCE.
1 |
P a g e
Advertisement
Table of Contents
Related Manuals for Member's Mark GR2334401-MM-00
Summary of Contents for Member's Mark GR2334401-MM-00
- Page 1 Assembly Instructions & User’s Manual Member’s Mark 4 Burner Gas Grill Item Number: 980304856 / 980302550 Model Number: GR2334401-MM-00 Customer Assistance : 1-888-837-1380 (spare/replacement parts) or Email: customerservice@rankam.com THIS ASSEMBLY MANUAL CONTAINS INPORTANT SAFETY INFORMATION. PLEASE READ AND KEEP FOR FUTURE REFERENCE.
- Page 2 Table of Contents Quality Statement ............................. 3 Important Safety Information ........................ 3 Before Assembly ............................3 Care & Use .............................. 3-6 Package Contents ..........................7-8 Product Information ..........................8 Components ............................9-13 Hardware ..............................14 Tools ................................14 Step 1 – Step 23 ..........................15-27 Warning ..........................
- Page 3 Quality Statement Important Safety Information • Please read all instructions carefully before assembling this product. • Where applicable, and for your safety, assembly by an adult is strongly recommended. • Use only vendor-supplied hardware to assemble this item. Using unauthorized hardware could jeopardize the structural integrity of the item.
- Page 4 USE AND INSTALLATION OF LP GAS CYLINDER (PROPANE TANK) BEFORE INSTALLING: The installation must conform with local codes or (in the absence of local codes) with either the National Fuel Gas Code, ANSI Z223.1/NFPA 54, Natural Gas and Propane Installation Code, CSA B149.1, or Propane Storage and Handling Code, B149.2, or the Standard for Recreational Vehicles, ANSI A 119.2/NFPA 1192, and CSA Z240 RV Series, Recreational Vehicle Code, as applicable.
- Page 5 INSTALLING GAS CYLINDER 1. Check that the cylinder valve is closed by turning the knob clockwise. 2. Place the cylinder into cylinder holder and tighten the fixing bolt. Place cylinder such that the valve opening faces the side burner in such a way that the hose is not kinked/damaged.
- Page 6 CONNECTION PROCEDURES 1. Make sure the tank valve is closed (turn valve clockwise until tight). 2. Check the tank valve to ensure it has the proper external male threads. 3. Make sure all burner valves are turned OFF. 4. Check valve connections, port, and regulator assembly for any damage or debris.
- Page 7 Package Contents P a g e...
- Page 8 Component Description Quantity Component Description Quantity Warming Rack Left Cart Panel Cooking Grate Right Cart Panel Flame Tamer Cart Base Assembly Grill Body Front Cart Assembly Left Side Table Left Door Left Side Table Right Door Panel Side Burner Grate Door Handle Side Burner Door Handle Bezel...
- Page 9 Components Component 1 Component 2 Component 3 Warming Rack Cooking Grate Flame Tamer Part No. MET-4B0104 Part No. MET-4B0105 Part No. MET-4B0106 Qty 1 Qty 3 Qty 4 Component 4a Component 4b Component 4c Grill Body – Left Lid Handle Grill Body –...
- Page 10 Component 4j Component 4k Component 4l Grill Body – Ignition Electrode & Grill Body – Ignition Electrode & Grill Body – Ignition Electrode Wire A Wire B & Wire C Part No. ELE-5B0002 Part No. ELE-5B0003 Part No. ELE-5B0004 Qty 2 Qty 1 Qty 1 Component 4m...
- Page 11 Component 5b Component 6 Component 7 Plastic Hook Side Table Panel Side Burner Grate Part No. PLA-4B0007 Part No. MET-4B0118 Part No. MET-6B0017 Qty 3 Qty 1 Qty 1 Component 8a Component 8b Component 8c Side Burner – Side Burner Lid Side Burner –...
- Page 12 Component 12 Component 13 Component 14 Thermometer Bezel Grease Collecting Tray Grease Cup Part No. MET-4B0123 Part No. MET-4B0124 Part No. MET-4B0125 Qty 1 Qty 1 Qty 1 Component 15 Component 16a Component 16b Tank Heat Shield Rear Cart Frame Match Holder Part No.
- Page 13 Component 20 Component 21 Component 22 Front Cart Frame Left Door Right Door Part No. MET-4B0133 Part No. MET-4B0134 Part No. MET-4B0135 Qty 1 Qty 1 Qty 1 Component 23 Component 24 Component 25 Door Handle Door Handle Bezel Locking Caster Part No.
- Page 14 Hardware Phillips Head Bolt, M4x10mm, Phillips Head Bolt, M6x12mm, Phillips Head Bolt, M6x10mm, Item No. B Item No. C Item No. D Qty: 6 Qty: 50 (8pcs pre-attached on Qty: 8 the related components) Phillips Head Bolt, M4x10mm Phillips Head Bolt, M6x35mm, LR6/AA Battery, Item No.
- Page 15 Step 1 – Step 23 （Two person for assembly is recommended） Step 1. Connect the Front Cart Frame (20) and Rear Cart Frame (16a) with 4 pcs Cart Frame Connecting Tube (28) then secure them with 8 pcs M6x12 Bolts (C). Do not fully tighten the bolts.
- Page 16 Step 3. Attach the Cart Base Assembly (19a) to the cart assembly using 7 pcs M6x35 Bolts (F). Step 4. Attach the Door Stopping Bracket (29) to the cart base assembly using 2 pcs M4x10 bolts Black (B). 16 | P a g e...
- Page 17 Step 5. Attach the Casters (25, 26 & 27) to cart assembly using 16 pcs M6x12 Bolts (C) as shown below. Step 6. Fully tighten all the bolts on the cart. Lock all 2 locking casters to prevent the unit moving. 17 | P a g e...
- Page 18 Step 7. Attach the Door Handles (23) and Door Handle Bezels (24) to the Right and Left Doors (21 &22) with the Plastic Inserts (31) using 8 pcs M6x10 Bolts (D). Step 8. Attach the doors to the cart assembly using 8 pcs M4x10 bolts Silver (E). 18 | P a g e...
- Page 19 Step 9. Attach the Tank Heat Shield (15) to the cart assembly using 4 pcs M4x10 bolts Black (B). Step 10. This step needs two people to complete! Put the Grill Body Assembly (4) carefully on top of the cart assembly. Secure the part in place with 4 pcs of M6x12mm bolts (C) as shown below.
- Page 20 Step 11. Disassemble the Thermometer Nut (J) and Thermometer Washer (I) from the Thermometer (30). Attach the Thermometer (30) and Thermometer Bezel (12) to the lid using the removed nut and washer. Step 12. Attach the Left Side Table Panel (6) to the Left Side Table (5) using 3 pcs M6x12mm bolts (C).
- Page 21 Step 13. Loosen 4 pcs pre-attached bolts M6x12 bolts (C) from the left side of the grill body and adjust to 3/16” clearance as shown. Position the holes on the side table assembly through the bolts at grill body. Push the side table assembly leftwards to lock it in place and tighten all bolts.
- Page 22 Step 15. Loosen 4 pcs pre-attached bolts M6x12 bolts (C) from the right side of the grill body and adjust to 3/16” clearance as shown. Position the holes on the side burner assembly through the bolts at grill body as shown below. Push the side burner assembly rightwards to lock it in place and tighten all bolts.
- Page 23 Step 16. Remove the 2 pcs pre-assembled bolts M4x8mm (H) from the side burner valve. Pull the side burner panel slightly forward (Step 1) and insert the valve outlet (orifice) into the side burner port (Step 2). Then insert the valve to the hole on Side Burner Control Panel.
- Page 24 Step 17. Insert the connector of the ignition wire to the terminal of the ignition electrode on the side burner assembly, as shown below. Insert the Control Knob (11) to the pin on the side burner valve. Apply light pressure to secure the knob firmly.
- Page 25 Step 19. Slide the Grease Cup (14) into the holding bracket at the bottom of the grease collecting tray. Be sure the handle is facing outward. Step 20. Place the Flame Tamer (3) as right direction on the grill as shown below. 25 | P a g e...
- Page 26 Step 21. Place the Warming Rack (1), Cooking Grates (2) and Side Burner Grate (7) on the grill as shown. Step 22. Install a LR6/AA Battery (G) into the igniter. 26 | P a g e...
- Page 27 Step 23. Your unit is fully assembled! Make sure to read and follow the Instruction Manual before using this appliance. Need Assistance? Visit us at: samsclub.com/membersmarkhelp 27 | P a g e...
- Page 28 Warning PROP 65 WARNING WARNING: This product can expose you to chemicals including benzene, which is known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov. WARNING ⚫ The appliance is designed for outdoor use only.
- Page 29 ⚫ Never use charcoal or wood briquettes in a gas grill. Flavoring chips must be contained in a metal smoking box to contain ash and prevent fires. ⚫ A Leak Test must be conducted prior to each use. ⚫ Keep a fire extinguisher on hand. Refer to your local authority to determine proper size and type.
- Page 30 LEAK TEST Although all gas connections on the grill are leak tested at the factory prior to shipment, a complete gas tightness check must be performed after assembly to ensure fittings were not damaged after leaving the factory. Periodically check the entire system for leaks following the procedures listed below.
- Page 31 3. If a leak is present, immediately turn off the gas supply and tighten the leaky fittings. 4. Turn the gas back on and recheck. 5. Should gas continue to leak from any of the fittings, turn off the gas supply and contact customer service department at 1-888-837-1380, 8am - 5pm, PST, Monday - Friday.
- Page 32 Danger DANGER (a) Do not store a spare LP gas cylinder under or near this appliance; (b) Never fill the cylinder beyond 80 percent full; (c) If the information in (a) and (b) is not followed exactly, a fire causing death or serious injury may occur.
- Page 33 Troubleshooting Problem Possible Cause Prevention / Solution Burner Will Not Light 1. LP cylinder fuel is used 1. Change a new, full LP cylinder. 2. Bad electrode spark. 2. Electrode or collector needs 3. Burner may not be adjustments. 3. Refer “To Reinstall The Main properly seated.
- Page 34 Care & Use Instructions LIGHTING INSTRUCTION: MAIN BURNER AND SIDE BURNER 1. Read instructions before lighting. 2. Open lid before lighting burner. 3. Make sure all control knobs are in the "OFF" position. 4. Turn ON gas valve from source or tank. 5.
- Page 35 LIGHTING INSTRUCTION: MATCH HOLDER TO LIGHT BURNER Turn off all burner valves. Make sure the lid is open. Place a lighted match on the match holder and hold next to the burner. Turn the control knob(s) to the “HI” position. Burner should light immediately. If the burner does not light in 5 seconds, turn the knob off and wait for 5 minutes then repeat above procedures.
- Page 36 STEEL SURFACES There are different stainless steel cleaners available. Always use the mildest one for cleaning first and scrub in the direction of the grain. To touch up noticeable scratches in the stainless steel, sand very lightly with dry 100 grit emery paper in the direction of the grain.
- Page 37 Clear clogged ports with a straightened paper clip. Never use a wooden toothpick as it may break off and clog the port. If insects or other obstructions are blocking the flow of gas through the burner, call customer service at 1-888-837-1380. MAIN BURNER REPLACEMENT: 1.
- Page 38 SIDE BURNER REPLACEMENT 1. Open the side burner lid and remove the side burner grate. 2. Remove the burner fixing nut as shown. 3. Remove the burner as shown. Step 2 Step 3 PROPERLY INSTALL THE BURNER Firmly seat the valve orifice into the burner tube. Make sure the valve orifice is inserted STRAIGHT into the burner tube.
- Page 39 Warranty Information 1. Manufacturer warrants this Product to be free from defects in workmanship and materials for a period of Ninety (90) days from the date of purchase, PROVIDED claims are submitted, in writing, with proof of purchase. 2. If any part of this item fails because of a manufacturing defect within the Limited Warranty Period, Manufacturer offers to replace such part(s) provided that such parts have not been improperly repaired, altered, or tampered with or subject to misuse, abuse or exposed to corrosive conditions.
- Page 40 NOTE: Please consider recycling all applicable packaging material. Distributed by Sam’s West Inc. 2101 SE Simple Savings Dr. Bentonville, Arkansas 72716-0745 Made in China Need Assistance? Visit us at: samsclub.com/membersmarkhelp 40 | P a g e...