Emerson Smart Wireless Gateway 1410 Reference Manual page 27

Reference Manual
00809-0200-4410, Rev BA
To remove the unit, see
1.
2.
Figure 3-2. Removing
Step 1
NOTICE
When mounting the unit in an electrical enclosure or other location, comply with the
appropriate local and governmental installation codes. Check to verify that the installer,
associated hardware, and installation equipment used have the proper certifications for the
specific type of installation being performed. Before installation, verify if local codes
require a permit and/or an inspection before energizing. When planning the installation,
account for routing the antenna cable within the enclosure.
Note
Do not mount the antenna within a metal enclosure. To avoid damage to sensitive RF
components do not remove protective cap from the Gateway SMA connector until ready to
install the antenna.
Mounting and connection
Figure 3-2.
Place a flat or rounded object (such as a screw driver) into the DIN clip and apply a slight
pressure downwards on the object.
Once the unit is released from the DIN rail pull backwards and down to successfully
disengage.
Section 3: Mounting and connection
Figure 3 2 Removing
Step 2
February 2014
19