Emerson Smart Wireless Gateway 1410 Reference Manual page 16

Section 2: Initial Connection
February 2014
Figure 2-1. Emerson Smart Wireless Gateway 1410 Housing Diagram
A. DIN rail clip.
B. SMA connector.
C. Power and Reset indicator lights. During normal operation the power indicator will be green. During a reset
the reset light will turn red. The reset switch should not be enabled during normal operation.
D. Ethernet port 2. This secondary port must be enabled when ordering to access the device. When this port is
activated, the factory IP address is 192.168.2.10. See
E. Ethernet port 1. Use for standard communication to the webserver or other protocols enabled on the gateway.
The factory IP address is 192.168.1.10. See
F. Five screw terminal block.
8
A
B
Power
C
Reset
D
24 VDC
(nominal)
E
Power Input
+
F
Table 2-1
S
-
.
Table 2-1
.
Reference Manual
00809-0200-4410, Rev BA
Serial
Modbus
A B
Initial Connection