Control Panel - Supero A+ Server 1022TC-IBQF User Manual

A+ Server 1022TC-IBQF/1022TC-TF User's Manual
IPMI LAN
Port Ports
USB COM VGA
Ports Port Port
6-2

Control Panel

Each control panel on the front of the chassis must be connected to the JF1 con-
nector on its assiciated serverboard to provide you with system control buttons and
status indicators. (When viewed from the front of the chassis, the serverboard on
the left is referred to as the primary serverboard and the serverboard on the right
as the secondary.)
These wires have been bundled together in a ribbon cable to simplify the connection.
Connect the cable from JF1 on the serverboard to the control panel PCB (printed
circuit board). Make sure the red wire plugs into pin 1 on both connectors. Pull all
excess cabling out of the airflow path. The LEDs inform you of system status for
the serverboard it is connected to. See Chapter 3 for details on the LEDs and the
control panel buttons. Details on JF1 can be found in Chapter 5.
Figure 6-1. Chassis Front View
Control Panel: Primary
Serverboard
SATA Drives
Figure 6-2. Chassis Rear View
PCI-E x16 Power
Slot Supply
InfiniBand
Port
(1022TC-
UID
IBQF only)
Button
6-2
Control Panel: Secondary
IPMI LAN
Port Ports
USB COM VGA
Ports Port Port
Serverboard
PCI-E x16
Slot
InfiniBand
Port
(1022TC-
UID
IBQF only)
Button