Table of Contents
Advertisement
A
r
+ Se
ver 1022TC-IBQF/1022TC-TF User's Manual
Unpacking
The motherboard is shipped in antistatic packaging to avoid electrical static
discharge. When unpacking the board, make sure the person handling it is static
protected.
5-2
Motherboard Installation
This section explains the first step of physically mounting the H8DCT-F/IBQF into
the SC808T-920B chassis. Following the steps in the order given will eliminate the
most common problems encountered in such an installation. To remove the moth-
erboard, follow the procedure in reverse order.
Installing to the Chassis
1. Access the inside of the system by removing the screws from the top cover of
the chassis, then lift the cover off.
2. Make sure that the I/O ports on the motherboard align properly with their
respective holes in the I/O shield at the back of the chassis.
3. Carefully mount the motherboard to the motherboard tray by aligning the
board holes with the raised metal standoffs that are visible in the chassis.
4. Insert screws into all the mounting holes on your motherboard that line up
with the standoffs and tighten until snug (if you screw them in too tight, you
might strip the threads). Metal screws provide an electrical contact to the
motherboard ground to provide a continuous ground for the system.
5. Finish by replacing the top cover of the chassis.
Caution: To avoid damaging the motherboard and its components, do not apply
any force greater than 8 inch-lbs. of torque on mounting screws.
5-2
Advertisement
Table of Contents
