Lt2002 Cloning Connections / Learning Setup - LG 32LH250H Setup Manual

Connections for the LT2002 Clone Programmer to Learn the Master TV Setup
Antenna
or CATV
Warning: Do not use the
LT2002 while any PPV card is
installed in the TV, or the Clone
Programmer device and the
PPV card will be damaged.
Note: These procedures assume that the TV is connected to a signal source, the TV source select-
ed is Antenna (RF) In, the signal is from an analog channel (not a digital channel), all equipment is
connected to power and turned ON, and the LT2002 Clone Programmer main menu (THE CLONE
HAS CONTROL OF THE TV) is displayed on the TV screen (see above and next page).
►
If an analog channel is not available, tune the TV to an Aux source, such as AV-1, for cloning purposes.
Before you begin cloning:
• The Master TV should be connected to a good, stable
signal from an over-the-air antenna or cable service
analog channel and should also be connected to power
(see above).
• Teaching and Learning is only possible between identical
model devices. (However, the LT2002 Clone Programmer
can store up to three different "Master" Setups.)
WARNING: Copying a blank or incorrect memory into a
TV, STB, or other device will cause the TV, STB, or other
device to operate erratically or become inoperable.
• Use an Installer Remote to operate Learning and
Teaching menus.
• Make sure the batteries in the Clone Programmer are
fresh.
206-4118

LT2002 Cloning Connections / Learning Setup

THE CLONE HAS CONTROL OF THE TV
THE CLONE IS VERSION XX
THE TV IS VERSION XX
THE SW IS REVISION XX
CLONE CLOCK= XX:XX
TV CLOCK= XX:XX
-PRESS ANY KEY TO CONTINUE.
-DISCONNECT CLONE WHEN DONE.
Master TV
• If batteries are removed, the Clone Clock Time will be lost.
• Decide if you want to set the time from the Clone
Programmer or copy the time to the Clone Programmer
from a compatible TV which has the clock set to the cur-
rent time.
• Setting the time and transferring it to the Clone
Programmer or other device is a separate procedure.
• Follow the connection diagram above to connect the
Clone Programmer to a Master TV display panel. After
Learning is complete,
display panel to "teach" it the Master Setup.
• Refer to "LT2002 Cloning Procedure Troubleshooting"
information to resolve problems.
Ferrite Core
(TDK, ZCAT
2035-0930)
connect to another identical TV
Continue the Cloning Setup on the next page.
Status
instructions
MPI
Reset
no communications
communications ok
®
QuickSet II Programmer
LT2002
ZENITH ELECTRONICS CORPORATION, LINCOLNSHIRE, ILLINOIS, USA
Clone Programmer
21