Remote Jack Pack / Tv Connections & Setup - LG 65EW960H Commercial Mode Setup Manual

Remote Jack Pack Setup
RJP Available? If you will use a Remote Jack Pack (RJP) in your system, set Installer Menu item 093
RJP AVAILABLE appropriately (for example, on a legacy model RJP: HDMI Mode, set RJP AVAILABLE
to 1). See Installer Menu detailed descriptions for further information.
093 RJP AVAILABLE
TV Connections
Caution: Make these connections ONLY after Master TV Setup and TV cloning procedures
are complete. Also, make sure to use the RJ-45 Control cable from the RJP cable bundle to
make the connection to the TV's RJP port. Do NOT connect a standard Ethernet cable to the
RJP port, as this may damage the TV and network equipment.
Refer to the figure below, and connect the RJ-45 Control cable from the RJP cable bundle to the RJP port
on the TV's rear jack panel. Then, connect HDMI and Composite Video/Audio connectors, as applicable,
for the cable bundle.
PTC SERVICE
SERVICE
(SERVICE ONLY)
RS-232C IN
OPTICAL
DIGITAL
AUDIO OUT
Note: RGB is not supported on these TV models. If an RGB source is connected to a legacy
RJP, you will see a brief message on-screen to indicate that this device is not supported.
206-4307
Reference: Remote Jack Pack / TV Connections & Setup
001
AUDIO/VIDEO IN
Connect Composite Video/Audio
connectors from RJP cable bundle.
(Composite Video on legacy RJP only.)
SPEAKER OUT
AUX LAN LAN
LINE OUT
(CONTROL)
HDMI IN 1
Connect HDMI connector
from RJP cable bundle.
ANTENNA/
AV IN
CABLE IN
USB IN 1
Audio In
RESET
MPI RJP Use Only
RJP Use Only
Connect RJ-45 Control cable from RJP
cable bundle.
Note: Before connecting the RJP
cable bundle, you may need to remove
the gray RJP cover that isintended to
prevent accidental misuse of the port.
IN 1
61