HYOSUNG GF125 Service Manual page 65

3-31 SERVICING ENGINE
● Remove clutch cover bolts and oil filter cap bolts, and
detach clutch cover by tapping with a plastic hammer.
● Remove clutch spring mounting bolts diagonally while
holding the primary driven gear, and remove clutch
pressure plate.
● After removal of clutch drive and driven plates, flatten
the lock washer and remove the clutch sleeve hub by
using the special tool.
09920-53710
● Take off the sleeve hub with the primary driven gear
ass' y.
OIL PUMP DRIVE GEAR, DRIVEN
GEAR AND PRIMARY DRIVE GEAR.
● Flatten the lock washer, then remove the nut, lock
washer and oil pump drive gear.
09910-20116
CAUTION:
This is a left-hand thread nut.
Clutch sleeve hub holder
Conrod holder