Governor Speed; Repairs; Service Parts - Husqvarna MC 18 9H Spare Parts & Operator's Manual

12

Governor Speed

It is critical that the Governor and throttle on all internal
combustion engines be adjusted properly. The engine speed
is preset at the factory for the proper sawing speed. It is
NOT normally necessary to change this setting. It should be
periodically verifi ed after the saw is placed into service. To
change the Governor setting, refer to the engine manual.
WARNING: Overspeeding the blade can result
in blade breakage and/or personal injury to the
operator and bystanders!! To assure the proper
Governor adjustment, determine the correct
blade shaft speed from the following chart.
Follow the engine manufacturer's instruction
procedure for Governor and throttle setting.
NO LOAD BLADE SHAFT AND ENGINE R.P.M.s
MODEL
9H 14"/18"
13H-14"/18"
16
BLADE SHAFT ENGINE
R.P.M.
2610
2610
The instructions for use and spare parts found in this document are for infor-
mation only and are not binding. As part of our product quality
improvement policy, we reserve the right to make any and all technical
modifi cations without prior notice.
The manufacturer accepts no
responsibility caused by unsuitable
13

Repairs

We carry out all repairs in the shortest possible time and at
the most economical prices. (See back page for our address
and phone numbers.)
14

Service Parts

For quick supply of spare parts and to avoid any lost time,
it is essential to quote the data on the manufacturer's plate
fi xed to the machine and the part number (s) to be replaced
with every order.
Write the Model Number & Serial Number here for future
reference:
Model Number:____________________
Serial Number:____________________
R.P.M.
3600
3600
use or modifi cations