Download Print this page

Reference Figures - Husqvarna MC 18 9H Spare Parts & Operator's Manual

Husqvarna mc 18 saw spare parts & operator's manual
Hide thumbs

Advertisement

Table of Contents
FIGURE 1
1A.
WATER VALVE: Use to control the water supply to
the diamond blade.
1B.
WATER INLET: Connect water hose at this garden
hose connection.
1C.
HANDLE ADJUSTMENT KNOBS: Use to adjust
handle height.
1D.
ENGINE STOP SWITCH: Stop Switch: Push down
to stop engine.
1E.
DEPTH CONTROL LOCK: Use to lock the position
of the Depth Control Hand Wheel.
1F.
DEPTH CONTROL HAND WHEEL: Controls lowering
and raising of the blade into and out of the cut.
10
FIGURE 2
2B
2A
2D
2A.
BLADE SHAFT NUT: Use to tighten the outer fl ange
against the diamond blade.
2B.
OUTER FLANGE: Use to hold the diamond blade in
position.
2C.
NOT USED
2D.
LOCKING PIN: Use to prevent the diamond blade
from rotating on the shaft during operation.
2E.
DIAMOND BLADE:
concrete and asphalt surfaces.
2F.
INNER FLANGE: Inside support used to hold the
diamond blade in position.
2G.
NOT USED
2H.
BLADE GUARD FRONT: The front section of the
blade guard.
2I.
BLADE SHAFT: Supports the blade fl anges and
2H
2 I
2F
2E
Use as the cutting tool for

Advertisement

Table of Contents
loading

  Related Manuals for Husqvarna MC 18 9H

This manual is also suitable for:

Mc 18 13h