Troubleshooting - Bissell CleanView POWER TRAK Plus User Manual

Troubleshooting

Vacuum cleaner won't run
Possible Causes
Power cord not plugged in
1
Vacuum cleaner or Tools won't pick up dirt
Possible Causes
Incorrect Height Adjustment
1
Hose not attached to suction opening
2
Twist 'n Snap Hose not securely attached
3
Crack or hole in Hose
4
Broken or worn Drive Belt
5
Rotating Floor Brush bristles worn
6
Rotating Floor Brush jammed
7
Clog in vacuum
8
Dirt Container full
9
Dirt Container or Upper Tank not installed properly
10
Filters are dirty
11
Vacuum cleaner is difficult to push
Possible Causes
Incorrect Height Adjustment
1
Visible dirt escaping from cleaner
Possible Causes
Dirt Container full
1
Filters missing or installed incorrectly
2
Dirt Container installed incorrectly
3
If suggested solutions for this or any function of the CleanView Bagless Power Trak Plus
do not correct the problem, call BISSELL Consumer Services.
WARNING:
To reduce the risk of injury from
moving parts and/ or electrical
shock, turn Power Switch OFF
and disconnect plug from electrical
outlet before performing
troubleshooting checks.
Remedies
Check electrical plug
1
Remedies
Adjust Powerfoot to correct height setting
1
Grasp Quick Reach Handle and firmly push Hose
2
Wand onto the suction opening
Make sure Twist 'n Snap Hose is snapped into
3
locked position
Check Hose and replace if needed
4
Replace Drive Belt, see page 11
5
Replace brush
6
Remove brush and clean debris from brush ends
7
Clear clog, see page 12
8
Empty Dirt Container
9
Position correctly and lock in place
10
Check and clean Upper Tank,
11
Pre-Motor and Post-Motor Filters
Remedies
Adjust Powerfoot to correct height setting
1
Remedies
Empty Dirt Container
1
Check Upper Tank, Pre-Motor and Post-Motor
2
Filters for correct installation
Pull out and re-insert Dirt Container correctly
3
13