Power Cord Storage - Bissell CleanView POWER TRAK Plus User Manual

Power Cord Storage

When you are done using your vacuum, return it to
the Upright position and store the Power Cord.
Turn vacuum cleaner OFF.
1.
Unplug Power Cord by grasping the plug (NOT the cord) and
2.
disconnect from outlet.
Loop Power Cord around Cord Wraps on side of
3.
vacuum cleaner.
How To Maintain Your Vacuum
To maximize your cleaning performance and extend the
life of your vacuum, it is very important that you empty
your dirt container and check and clean your Filters
frequently. Perform the following maintenance steps:
Empty the Dirt Container when the dirt reaches the "Full"
1.
line on the side.
Check the Upper Tank and Pre-Motor Filters at least once a
2.
month and clean or replace as needed.
Clean or replace the Post-Motor Filter every three to six months.
3.
Note: More frequent Filter cleaning may be
necessary if you are vacuuming new carpet,
fine dust, or have allergy concerns. Follow the
instructions on the following pages to perform
these simple maintenance steps.
Empty Dirt Container
The Dirt Container needs to be emptied when the dirt
reaches the "Full" line on the side of the Container.
Unplug cleaner from electrical outlet.
1.
Slide the Lock 'n Seal Lever to the "Unlock" position.
2.
Grasp handle and pull the Dirt Container straight out to
3.
remove from vacuum.
Empty dirt into garbage container.
4.
Put the Dirt Container back in the vacuum and slide the
5.
lever to the "Lock" position.
Note: The Dirt Container may be washed in
warm water with a mild detergent. Make sure it
is completely dry before using again.
WARNING:
To reduce the risk of
electric shock, turn
Power Switch OFF and
disconnect plug from
electrical outlet before
performing maintenance
or troubleshooting
checks.
Tip:
For maximum cleaning
performance, check
and clean or replace all
Filters as suggested.
Unlock
Position
Full Line
Lock Position
9