Enable/Disable Form Feed Mode - BayTech 24SII Owner's Manual

&
# !      
OPTION ACCESSIBILITY: Through any serial computer port.
By responding to the Enter Request: message at the end of the main
configuration menu (see Section 8.1 ) with "8" for any serial module or
"7" for the M24SII-V02 high speed parallel module (Enable/Disable
Form Feed Mode), you may enable form feed and select when form
feed occurs, or disable form feed.
The Model 24SII DES will respond with:
Enter Request :8
-------------------------------------------
| Port | Logical Name
| |
-------------------------------------------
| 1 |Device A
| 3 |Device C
| 4 |Device D
-------------------------------------------
Enter Port Number (ENTER=Exit) :
Enter the number of the port for which you wish to set the Form Feed
Mode and then strike the Enter key. For example, if you entered "3"
for Port 3 and Enter, the Model 24SII DES will respond with:
Form Feed at the Beginning of Printing is (OFF)
Enter 1 for ON, 2 for OFF, ENTER
You should then enter "1" if you wish to enable form feed at the
beginning of printing, "2" if you wish to disable form feed at the
beginning of printing, or strike the Enter key if no change from the
present condition is required. For example, if you entered "1", the
Model 24SII DES will respond with:
Form Feed at the Beginning of Printing is (ON)
Enter 1 for ON, 2 for OFF, ENTER
| Form feed | I.D.|
(Computer) |Begin| End | Page|
| Off | Off | Off |
| Off | Off | Off |
| Off | Off | Off |
for no change :
for no change :