Table of Contents
Advertisement
CAUTION: If you have a M24SII-V07 installed as Module 1, do not
configure Port 1 of this module for any baud rate higher than 115,200
or you will locked out of configuration mode and unable to program
the various features of the Model 24SII.
The Model 24SII DES will respond with:
Enter Request :6
Bidirectional
---------------------------------------------------
| Port |
Baud | Word | Stop |Parity|
|
|
Rate | Size | Bits |
---------------------------------------------------
|
1
|
|
2
|
|
3
|
|
4
|
--------------------------------------------------
Enter
Port Number (ENTER=Exit) :
You should enter the number of the port that you wish to reconfigure,
and then strike the Enter key. For example, if you sent "2" and Enter,
the Model 24SII DES will respond with the current status of Port 2 and
a menu of the available options:
Bidirectional
---------------------------------------------------
| Port |
Baud | Word | Stop |Parity|
|
|
Rate | Size | Bits |
---------------------------------------------------
|
2
|
--------------------------------------------------
Exit/Save......1
Set Baud Rate..2
Set Word Size..3
Enter Request :
You may now reconfigure Port 2 by selecting the appropriate option
(1-6) from the menu.
NOTE: The M24SII-V07 module will also show Set 4-Wire/8-Wire as
item number 7 .
9600|
8
|
1
|None
9600|
8
|
1
|None
9600|
8
|
1
|None
9600|
8
|
1
|None
9600|
8
|
1
|None
Set Stop Bits.....4
Set Parity........5
Set XON/XOFF......6
Xon / Xoff |
| Xmit | Recv |
|
Off | Off
|
|
Off | Off
|
|
Off | Off
|
|
Off | Off
|
Xon / Xoff |
| Xmit | Recv |
|
Off | Off
|
Advertisement
Table of Contents
