Table of Contents
Advertisement
Model 24SII DES CONFIGURATION GUIDE
Menu Options
Factory
Default
Enable/Disable
Beginning: off
Form Feed
Mode
Ending: off
Program I.D.
"This Print Job
Page Message
is for :"
Enable/Disable
off
I.D. Page
Message
Select Print
Before print
Schedule for
job
I.D. Page
Default Printer
0-0
Assignment
(contention
mode) for all
computer
ports.
User Options
Beginning: on or off
Ending: on or off
Max 80 characters.
ex. "PLEASE ROUTE THIS
PRINT JOB TO:"
Printer commands to
increase the font size used
for this page may be
entered as part of the 80
characters and will not
appear on the printed page.
on or off
Before print job or after print
job
You may configure the
Default Printer Assignment
to be any module and port
number of a port defined as
a printer port.
Notes
(beginning) has been
selected. Mode B
recognizes the end of a
print job only by inactivity
timeout periods. It will not
recognize manual
disconnect codes.
Used if you wish to have
the Model 24SII DES
automatically sent a form
feed character before
and/or after each print job.
Helpful when sending
DOS print jobs to an HP
Laserjet printer.
The same message is sent
for each device if I.D.
Page Message is enabled
for that port. It will
automatically be followed
with the logical port name
of the PC sending the print
job.
These should all be set the
same (beginning or end)
for ports where I.D. Page
Message is enabled to
make it easier to
determine whose print job
it is.
Any print job sent without a
port select sequence after
power-up will automatically
be routed to the default
printer.
Advertisement
Table of Contents
