NOTE: Ports using this configuration will support XON/XOFF
handshaking only. You must enable XON/XOFF handshaking in
configuration mode for these ports (see Section 8.8.1 ) and on the
equipment that will connect to these ports.
Ports on the M24SII-V07 module using EIA-232 Protocol, 4-wire
Operation, and bidirectional Printer Sharing Mode utilize the following
pins and signals for communication:
RJ-11 PIN-OUT INFORMATION
PIN
SIGNAL
DIRECTION
EIA-232
1
NC
----
2
TX
Output
3
RX
Input
4
GND
----
If you are connecting a device to a port on the M24SII-V07 module
using EIA-232 Protocol, 4-wire Operation, and bidirectional Printer
Sharing Mode, please see Appendix A.7.2 for device adapter pinouts
and recommended cabling.
DESCRIPTION
No connection
Transmit Data
Receive Data
Signal Ground